Modeling > NURBS Modeling > NURBS Modeling Reference > NURBS menus >  Edit NURBS  > 

Edit NURBS > Untrim Surfaces

 
 
 

Undoes the last trim or all trims to a surface.

Related topics

Edit NURBS > Untrim Surfaces >

Keep Original

If you set Keep Original to On, the untrimmed surface is created and the original trimmed surface is retained. If you select Off, the untrimmed surface replaces the trimmed surface.

Untrim

Select All to remove all trimming information from the surface. All curves-on-surface are also displayed again. All is the default.

Select Last to cancel the last trim operation. For example, if a surface had been trimmed three times, this option shows the result as if it had only been trimmed the first two times.

Please send us your comment about this page

Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License