sine

 
 
 

Nonlinear Deformer Attributes

Select one of the following options.

Low Bound

Specifies the extent of the sine wave along the deformer’s local negative Y axis. Values can be negative numbers or zero. Use the slider to select values from negative 10.000 to 0.000. Default is ?1.000.

High Bound

Specifies the extent of the sine wave along the deformer’s local positive Y axis. Values can be positive numbers only (minimum value is 0.000). Use the slider to select values from 0.000 to 10.000. Default is 1.000.

Amplitude

Specifies the amplitude (maximum wave amount) of the sine wave. Use the slider to select values from ?5.000 to 5.000. Default is 0.000 (no wave).

Wavelength

Specifies the frequency of the sine wave along the deformer’s local Y axis. For greater frequency decrease the wavelength, and for lesser frequency increase the wavelength. Use the slider to select values from 0.100 to 10.000. Default is 2.000.

Offset

Specifies the location of the sine wave relative to the center of the deformer handle. Changing this value can create a wriggling effect. Use the slider to select values from -10.000 to 10.000. Default is 0.000.

Dropoff

Specifies how the amplitude decays. Negative values specify a decay towards the center of the deformer handle (minimum is -1.000), and positive values specify a decay away from the center of the deformer handle (maximum is 1.000). Use the slider to select values from -1.000 to 1.000. Default is 0.000 (no decay).

Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License