SubdivideEdge Op Property Editor

 
 
 

Divides one or more edges evenly by adding points, and it optionally subdivides polygons by connecting the corresponding points on multiple edges.

To apply: See Subdividing Polygons and Edges {Polygon Modeling].

To redisplay: Select the modified polygon mesh object then choose Edit Properties Modeling Properties from the Edit panel and click the SubdivideEdge Op tab.

Subdivisions

The number of edges into which to divide the selected edges. 1 = no new edges.

Curvature Continuity

Modifies the position of the new point(s) based on the surrounding surface curvature. A value of 0 gives a flat result (no curvature), while 1 gives full curvature continuity. You can enter smaller and larger values for an exaggerated effect.

Parallel Edge Loop

Adds a new point at the same position on all parallel edges.

Connect

Connects corresponding points on opposite edges, if multiple edges were selected.

   

Parallel Edge Loop and Connect both off.

Connect on.

   

Parallel Edge Loop on.

Parallel Edge Loop and Connect both on.