Thank you for downloading Autodesk® Revit® Interoperability for Navisworks Simulate® 2015 Security Update Release.
This readme contains the latest information regarding the installation and use of this update. It is strongly recommended that you read this entire document before you apply the update to your licensed copy of Autodesk Navisworks Simulate 2015. For reference, you should save this readme to your hard drive or print a copy.
Issues Resolved by this Security Update Release
This update release addresses the Heartbleed vulnerability - a security bug in the open-source OpenSSL cryptography library. Heartbleed is registered in the Common Vulnerabilities and Exposures system as CVE-2014-0160. For more information, please visit the CVE dictionary at http://cve.mitre.org
This update is for the following Autodesk products running on all supported operating systems. Be sure to install the correct update for your software.
Autodesk Revit Interoperability for Navisworks Simulate 2015
This update can be used with the following operating systems:
As you prepare to install this update, keep the following in mind:
In order to apply this update, you must have administrative privileges to install and uninstall products.
Under some circumstances, you may be asked to provide the original installation source.
If you installed Autodesk Navisworks Simulate 2015 from the DVD or USB, you will be asked to insert the disk or USB during installation of the update. Please have the disk or USB available before starting.
If you downloaded and installed Autodesk Navisworks Simulate 2015 from the web and later deleted the extracted files (default location of extracted files is C:\Autodesk\WI\Autodesk Navisworks Simulate 2015), the update will not be able to continue. In that case, you should follow the below procedure:
- Obtain the Web download file and save it to your computer.
- Double click the download file and allow it to extract its files, noting where they are being saved.
- When the Autodesk Navisworks Simulate Installer screen appears, click "Cancel".
- Continue with update installation as described in the Installation Instructions.
Backup Custom Files
Back up all customized files before starting.
Special command line switches are available for administrators.
/q - Suppresses the completion message after this update is applied. This is useful if you use a script or batch file to apply this update to multiple computers.
/e - Extracts the MSP file from the update executable.
Follow these instructions to install this update on a single computer.
Note: This update cannot be uninstalled to revert Autodesk Revit Interoperability for Navisworks Simulate 2015 to its pre-update state. If you need to remove the update, please uninstall Autodesk Navisworks Simulate 2015 and then reinstall it.
Copyright © 2014 Autodesk, Inc.